Conduit Math
Menu

Conduit bending and electrical field guides

Practical explanations, worked examples and the assumptions behind each result.

  1. Choose your offset method

    Why a manufacturer’s chart and ideal geometry give different marks.

  2. Measure take-up before the stub

    Use the deduction and alignment for your exact bender.

  3. Mark a three-point saddle

    Locate the center and return marks without mixing methods.

  4. Find the true rolling offset

    Treat the rise and roll as the two legs of a triangle.

  5. Get voltage-drop inputs right

    Length, impedance and power factor each change the estimate.

  6. Work in fractions or millimetres

    Keep the measurements familiar without losing the underlying precision.

  7. Mark back-to-back 90s with the arrow and star

    Lay out a 12-inch stub and a 24-inch back-to-back dimension using two different tape origins.

  8. Lay out a four-point saddle over a wide obstruction

    Work from a known first mark to find the two slopes, the flat top and the total shrink.

  9. Stagger parallel conduit offsets

    Use conduit center spacing to find how far to shift the marks on each adjacent run.

  10. Find transformer full-load current from kVA

    Read primary and secondary line currents for a 50 kVA transformer in single-phase and balanced three-phase examples.

Browse the glossary