Conduit Math
Menu

Mark back-to-back 90s with the arrow and star

Lay out a 12-inch stub and a 24-inch back-to-back dimension using two different tape origins.

Measure the first mark from the pipe end

For a 12-inch finished stub and a verified 5-inch take-up, measure 7 inches from the pipe end. Align the arrow with this mark and form the first 90°. The 5-inch deduction belongs to the shoe and conduit combination in this example.

Move the tape to the back of the first 90°

For a 24-inch outside-to-outside dimension, measure 24 inches from the back of the finished first bend along the straight leg. Mark that point and align the star on the shoe with it. Adding the first 7 inches or subtracting the take-up again would move the second bend.

Check the finished U

Check that both legs lie in one plane and measure across their outside faces. A tight U needs enough room for the shoe to make the second bend. Klein illustrates the arrow and star alignment in its back-to-back bend instructions.

Source · Klein Tools, Conduit Bender Guide, “Back to Back Bends,” pp. 4–5.