Conduit Math
Menu

Measure take-up before the stub

Use the deduction and alignment for your exact bender.

One height, one deduction

For a hand-bender arrow layout, subtract take-up from the required finished stub height. A 12-inch stub with a verified 5-inch take-up puts the arrow at 7 inches from the end.

Read the shoe

Take-up belongs to a specific bender, conduit material and trade size. A value from another shoe can put every bend in the wrong place. Use the manufacturer reference or a measured calibration.

Keep the alignment convention

Hand-bender arrows, mechanical hook fronts and hydraulic saddle edges are different references. The reference library names each alignment. Do not carry a deduction over to a different alignment mark.

Respect the minimum stub

A positive answer is not enough to establish that a stub can be bent. Check the published minimum stub and the bender setup before making the bend.

Source · Klein Tools, Conduit Bender Guide, “90° Stub-Up Bend,” p. 2.